SawStop Zero-clearance Table Insert for »Jobsite Saw Pro« Circular Bench Saw
Product no.:
721650K
Brand:
SawStop
€30.00 €25.21
per piece(s)
Delivery time approx. 3-5 working days
- Dimensions 115 x 400 mm
- Fits SawStop »Jobsite Saw Pro« Circular Bench Saw
- Machine/Accessory Accessories
- Machine type Circular bench saw
Description
For precise, tear-out-free cuts
The uncut surface of the table insert allows precise customisation between insert and saw blade depending on the blade type and kerf width. Lower the blade, position the zero-clearance insert, level and lock it in place, then slowly raise the running saw blade. As the blade cuts through the insert, a perfectly matched kerf is created between blade and insert. This provides optimal support for the workpiece and reduces the risk of tear-out.
Advantages:
Advantages:
- Positive-locking mechanism allows for tool-free use
- Positioning screws ensure a precise and secure fit in the table
- Pre-cut slots accommodate riving knife and SawStop blade guard
The Active Injury Mitigation (AIM) system by SawStop
This revolutionary safety technology was developed by SawStop to stop the circular saw blade the moment it comes into contact with skin.
The saw blade is supplied with a low electrical current. This voltage is continuously monitored on the opposite side of the blade. If the blade comes into contact with skin, the electrical signal changes because the human body is conductive. Once a threshold value is undercut, the system triggers within just 25 microseconds. At that moment, a fuse wire melts, releasing a preloaded spring mechanism that propels an aluminium brake block into the spinning blade with high force. The brake stops the blade in approximately 5 milliseconds. Due to the sudden deceleration, the blade is simultaneously retracted below the table surface and pulled away from the point of contact – typically a finger.
Although minor skin injuries such as abrasions may occur, the system effectively reduces the risk of serious cuts.
After activation, the brake cartridge and saw blade must be replaced. However, the replacement process is user-friendly and can be completed within a few minutes.
The saw blade is supplied with a low electrical current. This voltage is continuously monitored on the opposite side of the blade. If the blade comes into contact with skin, the electrical signal changes because the human body is conductive. Once a threshold value is undercut, the system triggers within just 25 microseconds. At that moment, a fuse wire melts, releasing a preloaded spring mechanism that propels an aluminium brake block into the spinning blade with high force. The brake stops the blade in approximately 5 milliseconds. Due to the sudden deceleration, the blade is simultaneously retracted below the table surface and pulled away from the point of contact – typically a finger.
Although minor skin injuries such as abrasions may occur, the system effectively reduces the risk of serious cuts.
After activation, the brake cartridge and saw blade must be replaced. However, the replacement process is user-friendly and can be completed within a few minutes.
Properties
| Dimensions: | 115 x 400 mm |
|---|---|
| Fits: | SawStop »Jobsite Saw Pro« Circular Bench Saw |
| Machine/Accessory: | Accessories |
| Machine type: | Circular bench saw |
Properties
| Dimensions: | 115 x 400 mm |
|---|---|
| Fits: | SawStop »Jobsite Saw Pro« Circular Bench Saw |
| Machine/Accessory: | Accessories |
| Machine type: | Circular bench saw |
Manufacturer
SawStop
SawStop is not only a manufacturer of high-quality circular bench saws, but also the inventor of the AIM system, which stops the blade within 5 milliseconds upon skin contact. SawStop’s revolutionary Active Injury Mitigation (AIM) system has saved thousands of fingers and prevented countless serious hand injuries in the United States since the company was founded in 2000. Since 2017, SawStop has been part of Tooltechnic Systems (TTS), which also includes Festool and Shaper.
