This float cuts on the pull stroke and is therefore ideally suited to removing material from the tenon shoulder without causing damage when reworking mortise and tenon cheeks. The conical blade allows for better visibility when working on edges.
The term »float« for an extra-coarse single-cut file goes back to the 19th century. Formerly developed for making wooden plane bodies, they are now also used for surfaces that are difficult to work on in cabinetmaking. A hardness of 52 HRC allows resharpening by hand.
- For hard materials and end grain
- For making wooden plane bodies
- For finishing mortises
- Creates smooth surfaces
- Controlled removal of material allows precise working
- Cut length55 mm
- Cross-section24 x 3 mm
- Overall length245 mm
Discover product in our flip catalogue:
Article out of stock - Article mid- September 2017 available
€59.00 per piece(s)
Prices incl. VAT
Lie-Nielsen Large Cheek Float, Mortise/Tenon Cheek
Article number 715168